Sunfire Subrosa SRS-210R Manuel d'utilisateur télécharger pdf (Page 8)

User's Manual

Control Panel Features continued

patch cords. Then connect a second

patch cord from these outputs to the

inputs of your main amplier. This will

allow your main speakers to operate

at frequencies above 70 Hz and the

subwoofer to operate at frequencies

below 70 Hz (see page 16).

13. Balanced (XLR) Input

Use this balanced input to connect

to the balanced line-level output of a

Home Theater preamplier or other

source. Balanced connections offer

superior noise cancellation over unbal-

anced connections, so if your preamp

has an XLR sub output, we recommend

that you use it.

14. Trigger Inputs

These two inputs can be used to

automatically turn on the sub amplier.

To do this, connect 12 VDC to either of

these terminals. Some Home Theater

preampliers, such as the Sunre

Theater Grand series, have matching

12 VDC Trigger outputs. When they are

turned on, the subwoofer will turn on.

15. Speaker Level Outputs

This is the connection to the subwoofer.

Use high-quality speaker wire.

The red post is the positive output, and

connects to the positive (red) post of

your subwoofer. The black post is the

negative, and connects to the negative

(black) post of your subwoofer. The

posts can accept bare wire, spade

terminals, and dual or single banana

connectors.

The amplier is designed to

power only the Sunre SubRosa

subwoofer. No other subwoofer or

speaker should be connected, or

this may lead to serious damage to

your equipment.

16. Line Fuse

The subwoofer is supplied with a con-

servative slow-blow type fuse to protect

the electronics.

Always unplug the power cord

before inspecting or changing the

fuse. Never use a fuse with a larg-

er current rating than shown on the

markings next to the fuseholder.

Use a small at screwdriver to pry

out the fuseholder and replace the

fuse.

17. IEC Linecord socket

The sub amplier comes with a detach-

able linecord that connects here.

US (120 VAC) MODEL: Connect

the linecord to the subwoofer before

connecting the other end to an 120

Volt, 60 Hz AC outlet. The outlet must

have a circuit rating of 8 amps or more

(a typical home circuit is rated at 15

amps).

Never plug the US (120 VAC)

Model subwoofer directly into

220-240 Volts AC as this will cause

catastrophic circuit failure.

11 12 13 14 15 16 17

8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Commentaires sur ces manuels

Pas de commentaire