Sunfire Subrosa SRS-210R Manuel d'utilisateur télécharger pdf (Page 20)

User's Manual

Specications

Amplier Output

2,700 watts rms

High Cut Filter

30 Hz - 100 Hz adjustable, with a

"Bypass" position

Frequency Response

18 Hz - 115 Hz (-3 dB)

Power Line Voltage

US model

120 VAC 50/60 Hz

International model

230 VAC 50/60 Hz

Dimensions

Amplier (H x W x D)

1.75" (1U) x 17" x 15"

44.5 mm x 431.8 mm x 381 mm

Subwoofer

14.25" x 44.5" x 3.5"

362 mm x 1130 mm x 88.9 mm

Weight

Amp: 18.4 lb. (8.35 kg)

Sub: 59 lb. (26.8 kg)

Subwoofer Finish

High gloss, ebonized rosewood

Line Power Consumption:

800 watts average, at maximum continu-

ous output. 8 watts at idle

2,700 watts peak, time limited basis

Output Levels:

Greater than 110 dB peak SPL (includes

room gain) from 18 Hz to 100 Hz. Mea-

surement is one meter, anechoic.

A typical Sunre subwoofer can be

expected to ‘best’ its specied minimum

peak SPL by several decibels.

Total Harmonic Distortion

Typically less than 1/10 of the funda-

mental between 18 to 80 Hz.

Input Sensitivity (full output):

250 mVrms from left input with volume

control at 0 dB, 60 mVrms volume con-

trol fully clockwise

*

0.75 Vrms from right input with volume

control at 0 dB, 200 mVrms volume

control fully clockwise

*

Input Impedance:

30 kΩ for Line-Level inputs

56 kΩ for Hi-Level inputs

40 kΩ for XLR input, each leg balanced

to ground

XLR Input

Pin 1 Ground

Pin 2 Positive

Pin 3 Negative

Drivers: dual 10 inch

Extra large neodymium magnets and

long throw mechanical design yield very

high back-emf. The result is extraordi-

narily high operating efciency – that is,

more acoustic output for each watt of

input.

Internal System Gain:

50 dB from left input jack to speaker

with volume control at 0 dB, 62 dB with

control fully clockwise

*

40 dB from right input jack to speaker

with volume control at 0 dB, 52 dB with

control fully clockwise

*

*

The Sunre subwoofer utilizes dif-

ferential gain on the left and right

inputs to retain both L+R and L-R

information.

12 VDC Trigger Input

Input voltage range: 5 -18 VDC

Impedance: approx 600 Ω

(20 mA @ 12 V)

Removable terminal block, and one 1/8”

Mono minijack, tip positive.

© 2007 Sunre Corporation.

All rights reserved. Sunre Corporation

reserves the right to improve its products

at any time. Therefore, specications are

subject to change without notice.

Manual 913-125-00 Rev C

20

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire